What is the operation procedure of the polyester embossing machine?

- Oct 29, 2018-

The use of polyester embossing machine can refer to the corresponding specifications. For example, check the hydraulic oil quantity before use. The height of the hydraulic oil is 2/3 of the height of the lower base. When the oil quantity is insufficient, it should be added in time. The oil embossing machine liquid is injected. Must be finely filtered before. Add pure 20# hydraulic oil to the oil hole of the lower base. The height of the oil level is seen by the oil standard rod, which is generally added to the height of 2/3 of the lower base.


At the same time, check the lubrication between the column shaft of the polyester embossing machine and the guide frame to refuel in time to maintain good lubrication. Then, the polyester embossing machine power supply can be turned on, the operating handle is moved to the vertical position, the oil return port is closed, and the motor start button is pressed, the oil from the oil pump enters the oil cylinder, and the driving plunger rises, when the hot plate is closed, The oil pump continues to supply oil, so that when the oil pressure rises to the rated value, the registration stop button is pressed to keep the machine in the stop pressure state. When the vulcanization time is reached, the handle is moved to lower the plunger to open the mold.


The temperature control of the hot plate in the polyester embossing machine is such that the rotary button is closed to start heating the plate, and when the temperature of the plate reaches a preset value, the heating is automatically stopped. When the temperature is lower than the set value, the plate is automatically heated, keeping the temperature at the set value.


In addition to temperature control, it is also necessary to master the operation control of the vulcanizing machine of the polyester embossing machine. According to the motor start button, the AC contactor is energized, and the oil pump works. When the hydraulic pressure reaches the set value, the AC contactor is disconnected and starts automatically. Record the vulcanization time. When the pressure drops, the oil pump motor starts to automatically replenish the pressure, and the set vulcanization time is reached. The alarm sounds, telling that the vulcanization time has arrived. You can open the mold, press the stop button, move the manual operation valve, and lower the plate. , can proceed to the next cycle.http://www.embochina.com/