Upper die speed and power output of non woven fabric embossing machine

- Apr 12, 2019-

The ammeter of the non woven fabric embossing machine is in accordance with the operating current of the ultrasonic wave during the operation, and the state of the welding head and the system resonance when it is idling is generally 0.4 to 0.6 A, depending on the output power. When the load is applied, it depends on the pressing area and the flower wheel and the complexity and size, usually from 1.0 to 2.5A.

 

Non-woven fabric embossing machine power output

The adjusted output power of the non-woven fabric embossing machine is adjusted to different file positions, and the ammeter reading will change.

 

Upper die speed of non-woven fabric embossing machine

The non-woven fabric embossing machine needs to effectively adjust the rotation speed of the flower wheel during the operation. Generally, the higher the number, the faster the rotation speed, and the faster the speed during operation, the lower the speed.

 

Lower die speed of non-woven fabric embossing machine

The non-woven fabric embossing machine adjusts the speed of the ultrasonic steel mold. The higher the number, the faster the speed is; the lower the speed.

 

Overload indication of non-woven fabric embossing machine

The red indicator light is on, indicating that the device is overloaded. At this point, you should stop immediately and check the cause until the fault is removed before you can continue working.

https://www.embochina.com/