Steps to properly install the Fabric Cloth Embossing Machine

- Oct 13, 2018-

Before the Fabric Cloth Embossing Machine is installed, it is necessary to disassemble the package, check the surface and various parts of the equipment for signs of damage, check whether the screws are loose, whether the electrical connectors are locked, and whether the accessories are complete. It can then be placed on a flat, hard floor, requiring the lace machine to be at least 0.5 m away from the heat source, and to ensure that the lace machine has at least 1 m in front of and behind, and at least 0.5 m of space on the left and right for operation.

 

Don't forget, check the voltage requirements on the back of the fabric embossing box and make sure the system is well grounded. Connect the device to the power and air supply. Be sure to turn off the power switch first. Pay attention to the voltage requirements of this unit: AC220V, 50-60Hz. In addition, the air line of the Fabric Cloth Embossing Machine is connected to a clean and non-lubricating compressed air source with a rated working pressure of 0.6 MPa.

 

Before using the Fabric Cloth Embossing Machine, you must be familiar with the functional descriptions of the various parts of the machine. The function of the vibration box should be emphasized. For example, the amplitude display refers to whether the resonance between the ultrasonic vibrator and the steel mold is appropriate; the rotary sound wave adjustment knob can change the reading, and is generally adjusted to below 50.

 

The upper mold speed and the lower mold speed of the fabric cloth embossing machine should be adjusted according to actual requirements; the manual/automatic switch is used for the change of the operation mode, the automatic gear position is reached, the flower wheel and the steel mold are automatically operated; The operation of the wheel and the steel mold is controlled by the pedals of the right foot. When the pedals and the steel mold are stepped on, the pedals and the steel mold are released and the operation is stopped.