Stainless steel plate embossing machine Installation and adjustment steps
The Stainless steel plate embossing machine can be used on various metal materials to print various patterns and patterns. When installing the stainless steel sheet embossing machine, first disassemble the package, check the surface and parts of the equipment for signs of damage, check whether the screws are loose, whether the electrical connectors are locked, and whether the accessories are complete.
The equipment is then placed on a flat, hard floor, and the Stainless steel plate embossing machine is required to be at least 0.5 m away from the heat source, and to ensure that it is at least 1 m in front and rear and at least 0.5 m in space for operation. Check the voltage requirements on the back of the vibration box and ensure that the system is well grounded; the air line is connected to a clean, non-lubricated compressed air source with a rated working pressure of 0.6 MPa.
In addition, the proper adjustment of the Stainless steel plate embossing machine plays a key role in its normal operation, quality improvement and performance maintenance. The first is to adjust the air pressure, the pneumatic valve is next to the embossing machine pressure gauge. The pressure is adjusted depending on the thickness of the processed material or the nature of the processing. When processing thick materials or embossing, the air pressure is higher; conversely, when the material is thin or seamed, the air pressure should be lower.
There is also the sound wave detection adjustment of the Stainless steel plate embossing machine When the adjustment, the embossing machine index does not decrease, but rises, and rotates in the opposite direction. The reading of the amplitude meter indicator is within 50, and the reading of the ammeter indicator below 0.6A is the best working point. Tighten the butterfly nut after adjusting the sound wave.