Overload indication and lower die speed of three-roll embossing machine

- Jun 14, 2019-

The three-roll embossing machine is mainly used for embossing, rolling, creping and rolling of various fabrics in the process of use, and also on non-woven fabrics, coatings, human leather, paper, aluminum sheets. Rolled trademarks, imitation leather patterns and various shades of patterns and patterns.

The upper die speed of the three-roll embossing machine can effectively adjust the height of the flower wheel when the operation is performed. When the operation is performed, the higher the number, the faster the rotation speed, and the faster the speed, and vice versa. The lower die speed of the three-roll embossing machine,

Adjust the speed of the ultrasonic steel mold, the higher the number, the faster the speed, and vice versa.

Manual/automatic switch for three-roll embossing machine

The three-roll embossing machine hits the automatic gear position, the flower wheel and the steel mold automatically run; when the manual switch is turned on, the operation of the flower wheel and the steel mold is controlled by the foot pedal of the right foot, stepping on the pedal flower wheel and the steel mold Start working, release the pedal flower wheel and steel mold and stop running.

The overload indication of the three-roll embossing machine mainly refers to the fact that the red indicator light is on, indicating that the equipment is overloaded. At this point, you should stop immediately and check the cause until the fault is removed before you can continue working.

www.embochina.com