Installation steps of the stainless steel plate embossing machine

- Dec 10, 2018 -

The stainless steel plate embossing machine adopts a powerful head, the pressure can be adjusted according to the needs, the pressure is even during operation, and the pressure of the embossing machine head can be adjusted freely. So what are the specific steps when installing?

The first is to remove the outer packaging, check whether the surface of the stainless steel plate embossing machine is intact, whether the parts are damaged, whether the screws are loose, whether the electrical joints are locked, and whether the accessories are complete. After the inspection is completed, care should be taken to place the equipment on a flat hard ground. The lace machine should be at least 0.5 m away from the heat source, and ensure that the lace machine has at least 1 m before and after, and at least 0.5 m space for operation.

At the same time, it should be noted that the connected power supply voltage meets the operational requirements and ensures that the system is well grounded. Moreover, the air line of the stainless steel plate embossing machine should be connected to a clean and non-lubricated compressed air source with a rated working pressure of 0.6 MPa. In operation, care should be taken to control the temperature. When the temperature of the plate reaches the preset value, the heating is automatically stopped. When the temperature is lower than the set value, the plate is automatically heated, keeping the temperature at the set value.

https://www.embochina.com/