Installation of ultrasonic embossing machine

- Aug 08, 2018-

1. Remove the packaging, check the equipment surface and the parts have no damage marks, check whether the screws loose, electrical connectors are locked, the accessories are complete.

2. The equipment should be placed on a flat hard ground, requiring the lace machine to deviate from the heat source at least 0.5 meters, and to ensure that the lace machine before and after at least 1 meters, around at least 0.5 meters of space in order to operate.

3. Check the voltage requirement of the sign on the back of the vibration box, and make sure the system is grounded well. 4. Connect the equipment with the power supply and gas source, note that the power switch must be turned off first.

Note the voltage requirements of this machine: ac220v,50-60hz

5. Air pipelines are connected to a clean and free from lubricant compressed air source, rated operating pressure of 0.6MPa. Before using the new machine, you must read the manual of the ultrasonic press, and be familiar with the contents of the manual.