Inspection and working status of hydraulic oil of stainless steel plate embossing machine

- Apr 20, 2019-

The stainless steel plate embossing machine checks the hydraulic oil before use. When the hydraulic oil height is 2/3 of the height of the base, when the refueling time is insufficient, the fine filtration should be performed before the injection. It stands on the next oil hole 20 and adds pure hydraulic oil. It is generally applied to two-thirds of the lower height stations through the oil level reference.

 

The stainless steel plate embossing machine needs to check the lubrication between the shafts of each guide column and refuel in time to maintain good lubrication.

 

Power, move the joystick to the vertical position, close the oil return port, press the button to start the motor, the oil enters the cylinder from the pump, the piston drive rises, when the hot plate is closed, the pump continues to supply, when the stop button is pressed, the oil The pressure rises to the desired value (14.5Mpa). n To register, the machine is in the state of stopping the packaging (ie, timing vulcanization), reaching the curing time, and moving the plunger to lower the handle of the mold.

 

The hot plate temperature control of the stainless steel plate embossing machine, when the operation is performed, the closing button SA1 is rotated to start the heating plate, and when the temperature reaches the preset value, the heating is automatically stopped. When the temperature is lower than the set value, the tablet is always heated at the set value.

 

Vulcanizer control operation: press the button to start the motor SB2, the AC contactor is energized, the pump runs. When the hydraulic pressure reaches the set value, the AC contactor is disconnected and the automatic recording starts the curing time. When the pressure drops, the pump motor starts to automatically pressurize. , reaching S. ET curing time, Xiang gas screams to notify the curing time is up, you can open the mode, press the buzzer stop button, move the manual valve, the board drops, may be the next cycle.

 

https://www.embochina.com/