Booting requirements and operation process of non-woven finishing machine

- Apr 13, 2019-

Before each booting, the non-woven finishing machine must check whether there are obstacles or people near the flying claws during the operation. When the non-woven finishing machine is running, it is strictly forbidden to contact or touch any part of the body, especially Flying claws.

 

When the non-woven finishing machine is in normal working, it is forbidden to frequently switch the operation buttons. It is strictly forbidden to change the electrical parameter setting value frequently. It is strictly forbidden to run for a long time. It is strictly forbidden to check and repair the electrical control circuit! Be sure to turn off the power, be sure to do it by a professional.

 

If the operator of the non-woven finishing machine cannot keep awake due to drinking or fatigue, it is strictly forbidden to operate, debug and repair. Other untrained or unqualified personnel are not allowed to operate the machine. It is strictly forbidden to tamper with the equipment, especially the mechanical transmission part. And electrical parts.

 

The insulation resistance and grounding resistance of the non-woven finishing machine are in line with national safety standards. However, when the machine is turned on for the first time or not used for a long time, it should be operated for 3 minutes to prevent some electrical components from getting wet. Operating environment temperature: 0 ~ 45 degrees Celsius; no condensation ice, 10-90% RH value. It should not be installed in places where the temperature is too high or too low and the space is too narrow.

 

Non-woven finishing machines should not be installed in harsh environments where there are sources, ventilation outlets, corrosive gases, etc. that are not suitable for machine use and maintenance.

https://www.embochina.com/